Jump to content

Tobashadow

Active Member
  • Posts

    444
  • Joined

  • Last visited

  • Feedback

    100%

Everything posted by Tobashadow

  1. You forget the part about that if that happens at a push of a button 8-12 hours later there is another frame sitting there to replace it. And who says you can't make a few spare frames ahead of time...
  2. I needed a cheap one, i got five for just a little more than one of them. Nice find
  3. My i guess you could call it enhanced or OG style carry permit expires this year. Is it a waste of money to renew it? Or does it add extra to the abilities?
  4. After years of building AR's etc and now the past couple years of 3D printed ones, I want to try one of the Polymer 80 G17 frames to experience that and compare to the 3D printed designs. But after that whole bit last year it's kinda got me on the edge, even tho it's"currently" 100% good just like my 3D printed ones are. Has anyone seen a place to buy one in person? Thanks
  5. Building your own gets you what you want the first time instead of rebuilding someone elses dream.
  6. 20 years go i had a sks do a slam fire with a full mag lol
  7. Ok I can blame my back which has been on a pain scale of 8 out of 10 lately for this one. I needed a distraction and decided to install the extended takedown and pivot pins on the AR pistol to match the new ones on the AR rifle. I did the pivot pin no issue, went to do the rear pin and accidently turned my clevis pin to the hole side and heard ping as the detent went into permeant you can't get to me spot. Well crap time to put it in the vase and pull the buffer tube nut and back off the rear plate, no biggie just get it done. Pulled it and got it all put back on and tight and the brace back on the tube, checked the pins out for movement and installed the upper back on and racked the charging handle and went well that didn't feel right and ohhhh crap. I forgot to install the buffer and buffer spring back in the lower Shake shake shake shake rattle rattle and there wo go far enough that the forward assist can move it forward into battery.
  8. Must be a slow exam group, the local one here that I am a member of does ours on Saturday mornings (or at least we did before Covid) and most people had theirs in the system by Tuesday.
  9. In that one in a million situation or 50 or so odd days from now the way it's going lol. I fully expect to die if my house is overrun, but I expect the ground to be wet and red when I fall. I may be short on my goto rounds currently in 5.56 etc. But I got plenty of Mosin rounds that will make body armor at a distance a non factor.
  10. When the 22 shortage hit a few years ago me and my teenage son seen the exact thing happen at walmart with them being on the phone posting them for sale immediately. So us both being night owls anyways would go there way early and spoil their fun buying the big bulk packs instead of them. We'd get off work at midnight, play games on the PlayStation or watch TV, head out at 6am and be sitting there watching Netflix on my phone, when they arrived grabbing chairs from sporting goods. We'd bag the buy then head home to sleep. They at first acted extremely annoyed that we were cutting into their business and tried to cut the line but the sporting goods manager knew what we were up to the first day after talking to us and shut that down hard. It became a fun game three times a week, over the next three weeks. They tried to one up us the second week and came in at 6:15 but we were already there, so we came in at 5 the next time and they came in at 6 and asked where they had been. We told them we was late due to stopping at the waffle house and was hoping they hadn't got there first. The annoyance to them and lesson to my son was worth the time, and the entertainment of their frustration was well worth it. It got to be more fun then watching TV etc just to screw them over. We ended up giving a bunch of it away at the time or selling at cost to people with kids.
  11. Well wouldn't that be a Disability Act violation?
  12. I wonder if you can get a service animal vest for a Clydesdale?
  13. If the pictures are not sensitive aka would you freak out if a stranger seen them, then why not do what I do? Ours are on a second drive, and three different free online storage places. Google Drive Dropbox Amazon Photos
  14. All good specs, I would ask what size gas port it has. This is the barrel I used - https://www.classicfirearms.com/arbarrel10-5m4parkerizedhbar1in8twist AR-15 10.5" Contour Barrel, .223 WYLDE, 1:8, Parkerized Premium Grade Parkerized AR-15 Contour Profile Barrel, 10.5",1 in 8 twist Gas port drilled for carbine length gas set up, and threaded for comp.Barrel Extension in rear with M4 feed ramps... drilled with a .093" gas port opening at carbine length. It has a .750 gas block diameter, ready to install into receiver..223 Wylde
  15. I built a 10.5 a couple years ago (and when I mean build I bought nothing assembled I did every pin from the BCG to the forward assist), it is setup with a carbine length gas system except with a much larger gas port. The barrel basically ends a half inch past the gas block but it will run on any ammo I have thrown in it including tons of Tula with not one failure. And it is nothing special I purchased everything as cheap as possible on sale everywhere to make a budget gun. That's the shortest personally I will ever make myself.
  16. There is a Used Explorer Sport Trac I have my eye to buy but it is in NC on a car lot. This will be a cash deal but is there anything special I need to know since I have never bought a car out of state before.
  17. My Series 95 which is basically the first year of the thunder without the thunder name stays at my side daily. It's not my carry weapon of choice anymore but it stays on in the first grab location. Shoots wonderfully and accurate from the first day i bought it new over 20 years ago.
  18. I'd like to put my hands on a aluminum and a polymer one before I decide which one to make my first attempt with and I'd hate to order and waste the money. Knoxville to Chattanooga area.
  19. The biggest problem with allowing the sheep to think we are required to keep them concealed like other states is that we wind up with the incident a few years ago at the Knoxville walmart with the cop going off on a guy cause his weapon was showing. I carry out of sight but it makes me feel comfortable knowing I don't have to freak out wondering if someone seen it or not. A friend from Ohio freaks out if he sees the outline in my pocket because just that can get him in trouble at home. I don't want that here for anyone of us.
  20. And again im frustrated with the ignorant idiots calling it a CCW, it is NOT a CCW it is a HCP. a CCW is a CONCEALED carry license, which is not what Tennessee has and confuses people that we must carry concealed like other states have to, and can cause problems with uneducated people.
  21. Was in there today and noticed at both doors was a armed security guard. Not a off duty officer but a security firm. Asked the cashier and she said a couple people quit the other day so they had to get outside security and acted a bit hesitant at the answer.
  22. Nothing, oh well atleast they said something around 9pm lol.

TRADING POST NOTICE

Before engaging in any transaction of goods or services on TGO, all parties involved must know and follow the local, state and Federal laws regarding those transactions.

TGO makes no claims, guarantees or assurances regarding any such transactions.

THE FINE PRINT

Tennessee Gun Owners (TNGunOwners.com) is the premier Community and Discussion Forum for gun owners, firearm enthusiasts, sportsmen and Second Amendment proponents in the state of Tennessee and surrounding region.

TNGunOwners.com (TGO) is a presentation of Enthusiast Productions. The TGO state flag logo and the TGO tri-hole "icon" logo are trademarks of Tennessee Gun Owners. The TGO logos and all content presented on this site may not be reproduced in any form without express written permission. The opinions expressed on TGO are those of their authors and do not necessarily reflect those of the site's owners or staff.

TNGunOwners.com (TGO) is not a lobbying organization and has no affiliation with any lobbying organizations.  Beware of scammers using the Tennessee Gun Owners name, purporting to be Pro-2A lobbying organizations!

×
×
  • Create New...

Important Information

By using this site, you agree to the following.
Terms of Use | Privacy Policy | Guidelines
 
We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.