Jump to content
  • ×   Pasted as rich text.   Paste as plain text instead

      Only 75 emoji are allowed.

    ×   Your link has been automatically embedded.   Display as a link instead

    ×   Your previous content has been restored.   Clear editor

    ×   You cannot paste images directly. Upload or insert images from URL.

  • Similar Content

    • By Luckyforward
      Any suggestions?
      Thanks!
    • By Clutch80
      I'm doing some loads to shoot out of a conversion cylinder in my 1851 Navy. The instructions for the cylinder are to use 38 Long Colt or 38 Special wad cutters. I've got a good bit of 38 LC brass and want to load 148 grain hollow base wadcutters to get better obturation/grip on the rifling. I haven't found any 38 LC load data for 148 grain wadcutters, but have the data for 38 special. The question is if it is safe to load the wadcutters in the 38 LC brass using the COL and powder charge listed for the 38 special loads. It seems to me that the space inside the case of the 38 LC with the bullet protruding 1/8 inch out of the case would be the same as in the 38 special case. The pressure listed in the Lee manual for the 38 special wadcutters is actually less than for the 150 grain round nose that I have been loading in the 38 LC brass so I think I'm safe there. I thought I'd bounce my logic off some experts before loading them. These are not hot loads by the way.
    • By WFM
      I was wondering if anyone has used .380+p ammo. I know most modern firearms say + p is ok for occasional use if it meets saami specs. Since there is no .380 +P specs, there is none saami approved. However I know of two companies making .380 + P ammo, Buffalo Bore and  Underwood Ammo.Just curious if anyone has tried it in their .380 pistols.

The Fine Print

Tennessee Gun Owners (TNGunOwners.com) is the premier Community and Discussion Forum for gun owners, firearm enthusiasts, sportsmen and Second Amendment proponents in the state of Tennessee and surrounding region.

TNGunOwners.com (TGO) is a presentation of Enthusiast Productions. The TGO state flag logo and the TGO tri-hole "icon" logo are trademarks of Tennessee Gun Owners. The TGO logos and all content presented on this site may not be reproduced in any form without express written permission. The opinions expressed on TGO are those of their authors and do not necessarily reflect those of the site's owners or staff.

Before engaging in any transaction of goods or services on TGO, all parties involved must know and follow the local, state and Federal laws regarding those transactions. TGO makes no claims, guarantees or assurances regarding any such transactions.

×
×
  • Create New...

Important Information

By using this site, you agree to the following.
Terms of Use | Privacy Policy | Guidelines