Jump to content
  • Similar Content

    • By Will
      I do not reload so looking for some ideas for this project. I need 25 .45 Long Colts for display in Cowboy belt.after talking to some Cowboy shooters they say
      Nickel ammo ,new or cleaned with no primer.  Brass will tarnish on leather.
      Round nose lead,250 grain or so..
      How would I crimp with no reloader?
      Tried David and several vendors at gun shows,no luck.
      Thanks
      Will
       
       
       
    • By vujade
      What is causing this and how do I fix it?  
      I'm using a Dillon 550.  Seating die in station 3 only seats the bullet.  I have a Lee Factory Crimp die in station 4.   Everything is perfect until the 4th station where I feel the case buckle.  I reseated the crimp die.  I put a good round in there, raise a dummy round and screw in the die until it makes contact.  Lower the dummy round and turn in 1/4 of a turn.  I raise it up, no issue; very slight crimp but not enough to hold the bullet well (I'm able to push hard and lower the bullet).  I screw in the crimp die 1/8 of a turn; and what you see below is what I get.  I've tried several cases including new never fired cases. 
      I must have loaded several thousand rounds of 223 by now and this is the first I've seen this.  I did not make any drastic changes.  In fact, prior to this, I was had loaded about 20 perfect rounds.  
       

    • By swiley383
      I have some range pick up 7.62x51 brass I picked up. I have a good load for my 308 brass using Reloader 15. I know 762 brass is sometimes thicker and less capacity. Will it be enough to cause a problem or should I back up my powder charge when using 7.62 brass? I have read both ways.

The Fine Print

Tennessee Gun Owners (TNGunOwners.com) is the premier Community and Discussion Forum for gun owners, firearm enthusiasts, sportsmen and Second Amendment proponents in the state of Tennessee and surrounding region.

TNGunOwners.com (TGO) is a presentation of Enthusiast Productions. The TGO state flag logo and the TGO tri-hole "icon" logo are trademarks of Tennessee Gun Owners. The TGO logos and all content presented on this site may not be reproduced in any form without express written permission. The opinions expressed on TGO are those of their authors and do not necessarily reflect those of the site's owners or staff.

Before engaging in any transaction of goods or services on TGO, all parties involved must know and follow the local, state and Federal laws regarding those transactions. TGO makes no claims, guarantees or assurances regarding any such transactions.

×
×
  • Create New...

Important Information

By using this site, you agree to the following.
Terms of Use | Privacy Policy | Guidelines