Last semi-organized middle TN shoot of 2010... Friday 12/31/10

[TGO David]

OK so here's the deal: I and several others have decided to get one last shoot in before the year ends, so we are meeting up tomorrow, Friday, December 31st for a trip to the CHMR range in Spring Hill.

If you want to eat lunch with us before shooting, be at the Burger King in Spring Hill at 11:30am. After that, be at the old Owl Hollow Gun Club range (CHMR now) at 12:30'ish. We'll wait until 12:00 noon at the restaurant but if no one else shows up, we're out of there and heading for the range early.

I will wear a TGO hat to make it easy to spot me.

I figure we'll shoot until about 2:00p ...or so and then I personally will be cutting out and heading home to get ready for the evening's activities.

If you need directions to the range:

CHMR

RSVP if you think you'll be there.

[Guest JHatmaker]

Count me in. I assume there's only one Burger King in Spring Hill for me to Google?

[TGO David]

Count me in. I assume there's only one Burger King in Spring Hill for me to Google?

Yes. It's over near the Publix shopping center.

[zgunbear]

I will try to make it. I need to join the range soon any way. I need to pattern my 870

[Daniel]

I am going to try and make it to lunch. I may get over to the range as well.

[Guest Guy N. Cognito]

Damnit! I just got home from 3 hours at CHMR.

[Daniel]

well... my wife finally put me looking for three MIA boxes of .22 and going to lunch with TGO people. I have been denied.

Mainly because I was going to bring my son along.

[Guest gw2and4]

I'm in. I'll be at the range around 11 with some other friends, so I'll hang out until the TGO crew arrives. See you then.

[JPS]

I'm coming.

[bigwakes]

I was planning a trip with a buddy at 1:45. I'll try to make it a little earlier.

[Mark A]

oops, I should have been paying attention sooner. I'm headed that way...

[Guest kirkosaurus]

I got there at 8:30 this morning and it was packed when I left at 11:30. Didn't think the place would be that busy today!

[zgunbear]

I joined for the new year. Met some great people there today. I need to set up my presses and start loading .45 acp and 12 gauge again

[Mark A]

Had a good time. Got a couple of things zero'd that needed zero'd. Good to see folks again