Lcordero52

Pm sent

CZ p10-c Optic ready 9mm Lyman 356402 dv mold CZ P10c 125gr mold drops 77gr zinc projectile 1.145 oal Shooters World Auto Pistol powder 4 rounds each Load test 5.5gr = stove pipe no good 6.0gr = better but stove pipe 6.3gr = soft shooting one stove 6.5gr = cycles good feels a little slow 6.8gr = nice cycle accurate Next load will be 7.0gr. I expect this load to be the one I go with depending on PSI signs. The 6.8 PSI signs were minimal and I am using magnum primers. A 7.0 load should end up like a 6.6 load with normal primers. Still need to chrono but my chrono is down and I need to send it back. Update 7.0gr was 1540 fps

Anyone here cast with zinc and if so, what are your thoughts?

Still available?

Open to trades Aero receiver set Faxon 18inch lightweight match grade gunner barrel (1/4 inch groups at 100 yards) low mass bcg 15 inch lightweight handguard Adjustable gas block 3.5 lb Trigger SightMark Citadel 3-18x50 Bipod Total setup weight with loaded mag is 12lb 1300 obo 140 rounds of mix 95gr vmax, 140gr sst, 143gr eldx, 143gr eldm, and 129gr sp. For an additional cost. No Shipping you must be able to own a firearm in the state of TN 615 three1088four9