Jump to content

Question About Home Repair / Utilities


kb4ns

Recommended Posts

I have an odd situation. Some of the wood around the top of my house is rotting. Not unusual, I know. But... one of the pieces is where the utilities come into the house and a tension wire is secured. Who do I need to contact about this since I don't like messin' with anything remotely close to power lines? Would a "handyman" be able to replace the wood and take care of detatching / reattaching the tension wire? Do I need an electrician? Or do I have to have the utility company come out?

Below is a picture of the area in question. Any help is greatly appreciated!

DSCF1490b.jpg

Link to comment
  • Replies 25
  • Created
  • Last Reply

Top Posters In This Topic

Popular Days

Top Posters In This Topic

A handyman can do that for you. You need to replace those trim boards (treated lumber would be nice), seal and repaint. If you're going to be there long, I highly recommend getting aluminum trim installed over the wood. Zero maintenance. :hiding:

Link to comment

As a licensed Home Inspector my recommendations would be to call the local power compnay. From the meter out it is there problem. See if they will replace the board it may cost more if they will do it. If you want to you can arrange for a licensed and insured electrican / contractor to replace the trim while the electric company is there to disconnect the power.

Link to comment

I appreciate it, guys.

From the meter out it is there problem.

Memphis Light Gas & Water's policy is that they don't handle anything once it hits the service drop outside of the weatherhead (other than the meter itself). I'm not sure whether or not they'd even offer the service of replacing the board. I'll have to ask.

I've got a buddy who is rather handy who is gonna swing by later and look at it.

Link to comment

Any handyman CAN do it, but at that point, they're property of the utility company. On the power lines, YOUR wires start at the splices right before they enter the weatherhead. No big deal if nothing happens. If that messenger gets away from whoever disconnects it, you're going to be paying some of the most expensive electrical guys around, and may damage the weatherhead and riser to boot. There's no way to kill the power at that point, except at the pole. There's gonna be a healthy amount of tension on that messenger unless it's a pretty short drop from the pole.

I would print that pic, go visit a local electrical contractor, and ask how they do it. Service entrance stuff can be tricky.

Link to comment
I appreciate it, guys.

Memphis Light Gas & Water's policy is that they don't handle anything once it hits the service drop outside of the weatherhead (other than the meter itself). I'm not sure whether or not they'd even offer the service of replacing the board. I'll have to ask.

I've got a buddy who is rather handy who is gonna swing by later and look at it.

I doubt that they would replace the board, but the messenger belongs to them.

Link to comment
Guest db99wj
Oh, it's available at the weatherhead. You probably wouldn't look as coherent as that guy though, being dead and all.

I take it you've never seen KB's "hair"! :hiding:

Link to comment
Guest db99wj
I'm sure he'd be happy to if he asked the wrong way as well!

...and probably happy if you didn't ask and he thought you might needed it!

Link to comment
Guest db99wj

Well his power is out, yes it went out again today due to today's storm, maybe it won't be charged!

I imagine he is in a really good mood!

I think he started a facebook fanpage called "My Amish Paradise"!

Edited by db99wj
Link to comment

And I'm back... In a record 2.5 hours!! Whoo hoo! I'm really getting tired of overhead power lines and wind.

And DB... Where are you gonna be Thursday morning? I need to taze you tell you something. :hiding:

Link to comment
Guest db99wj
And I'm back... In a record 2.5 hours!! Whoo hoo! I'm really getting tired of overhead power lines and wind.

And DB... Where are you gonna be Thursday morning? I need to taze you tell you something. :)

:P

:hiding:

Link to comment

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

TRADING POST NOTICE

Before engaging in any transaction of goods or services on TGO, all parties involved must know and follow the local, state and Federal laws regarding those transactions.

TGO makes no claims, guarantees or assurances regarding any such transactions.

THE FINE PRINT

Tennessee Gun Owners (TNGunOwners.com) is the premier Community and Discussion Forum for gun owners, firearm enthusiasts, sportsmen and Second Amendment proponents in the state of Tennessee and surrounding region.

TNGunOwners.com (TGO) is a presentation of Enthusiast Productions. The TGO state flag logo and the TGO tri-hole "icon" logo are trademarks of Tennessee Gun Owners. The TGO logos and all content presented on this site may not be reproduced in any form without express written permission. The opinions expressed on TGO are those of their authors and do not necessarily reflect those of the site's owners or staff.

TNGunOwners.com (TGO) is not a lobbying organization and has no affiliation with any lobbying organizations.  Beware of scammers using the Tennessee Gun Owners name, purporting to be Pro-2A lobbying organizations!

×
×
  • Create New...

Important Information

By using this site, you agree to the following.
Terms of Use | Privacy Policy | Guidelines
 
We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.