Alleycat72

Yes and 308 mags

RRS makes a really good trypod, but it's expensive. Two Vets tripod makes a carbon fiber that's cheaper and good. Less expensive. I use this. https://stores.hogsaddle.com/pig0311-g-field-shooting-tripod-od-green/ Cheap and effective. Ball heads are a bit different. RRS anvil 30 is fantastic, but you don't have an independent pan feature. If you're starting off with a trypod, you'll have a learning curve. Kinda ruff on a $1500 trypod. I use this head. https://www.amazon.com/SUNWAYFOTO-XB-52DL-Tripod-Compatible-Profile/dp/B00IYEQMW4?gQT=2 I changed the clamp. It will use arca rail or pic. It's a good rig, but it's heavier than a RRS

35mm The 18mm if you want to run it on a helmet

I've run Trijicon and N-vision. At the moment I have a N-vision nox and a N-vision xrf. Both are fantastic. Iray has some good stuff also. I also run a pvs14 with a helmet. I've been night hunting for several years on permits and hog/coyote hunting in states were it's legal. What do you need to know?

It involved rabbits and a coyote so kinda the same. LOL

So is this a bad time to mention i was recently in 20° weather with a rifle, trypod, and my underwear and nothing else. It was 2:30 in the morning so no one was blinded.

Be very careful with this setup. Your hand will be forward of the muzzle. The bullet will be traveling through a suppressor, but suppressors can fail. Your hand will also get hot so a handguard cover could be a good idea. A small hand stop on the handguard where the muzzle ends is also a good idea. You will probably never shoot it without a can, but if you do....you'll never do it again if your hand was forward.

.

.

..

I don't know much about him. I'll have to look at some of his podcasts.

.

PM with shipping cost

If adjusted correctly, no. If you want less tension on the handle, you will sometimes find the handle about 1/2" back when the gun locks open. It's just adjusted with an alien wrench.

I'll see if I can get it in a small flat rate box.

The side charger uses an adjustable detent to keep the charging handle from moving back and forth. It needs to be adjusted from time to time. The newer model has a trigger type mechanism that acts as a latch. I looks a bit like a charging handle latch on a conventional ar15

I can for the cost of shipping.

No. The bolt cam needs to be replaced, but it comes with the cam.

It's a Gibbz side charger without the little trigger.

Barrel and bolt head. Brass and some bullets. Really expensive mags. I've taken it to Texas once and it did great. Shot a few deer and it's great for that. I've never shot a factory round through it. Mostly shot cutting edge. It's probably pushing 300 round. I just can't keep dropping expensive brass in Texas fields. Columbia or South Nashville

Lol. l Came here to look at the 40mm ammo.

750 to 700.

.