STEEL TARGET IN NASHVILLE

[rugerla1]

Innovative Targets is in Lascassas.
 
http://www.innovativetargets.net/

Good guys running that place, sent several people to them and they are all very happy with the plates and customer service

[seez52]

used to shoot at old brake disks, 223 and 308 can punch right through.

[Spots]

Make sure you use hardened steel. Soft steel will crater and can eventually cause jacket and bullet ricochets if it's to thick to punch through. You could probably order a set of steel AR500 body armor plates and the shipping would be resonable

Sent from behind the anvil

[Sunfish]

5/8 T 1 is good for AK and AR. I cleared it at 600ft with a Cupro-Nickel 8mm. I hang it from a fairly long log chain and it swings wildly when you nail it with something that has a lot of down range energy.  The next one I make will have two chains on the corners instead of one in the center.

[raildog]

Got my AR500 1/2" from Loftus steel in Nashville called them gave them the dimensions I wanted and before I could drive from Murfreesboro to their shop in West Nashville they had them cut out and ready to go

[DavidD]

Got my AR500 1/2" from Loftus steel in Nashville called them gave them the dimensions I wanted and before I could drive from Murfreesboro to their shop in West Nashville they had them cut out and ready to go

That was going to be my suggestion. Just have them made. Loftis Steel - 4204 Charlotte Ave. - (615) 463-9191

[robertb]

Check with a heavy equipment dealer. Bulldozer blades and dump truck beds are usually AR500.


Sent from my iPhone using Tapatalk