RED333

45ACP, Powder( super target aa is an old powder?) and weight(I found 1 listing and it was 9.3 grans). I did find a lot of load data using Titegroup. I do not reload 45ACP, but do reload 44mag, 40 S&W, 45 Colt, 38, 357, 25ACP and use Titegroup in all and have very good results with the powder. 223 might be OAL, or a number of other things. Magazines, feed ramps, dirty rifle, bullet used. So many variables in reloading, have you read up?

If you are new to reloading I suggest a single stage press, reloads 1 case at a time. Have you read up on reloading? What powder and charge weight are you using in 45ACP? What is the OAL of the 223?

Thank God I packed the semiautomatic for hunting!

Or, if you can legally own a fire arm, buy from a legal firearm owner and no back check involved. Welcome to the free state of TENNESSEE !!!

It come in at 650 LBS, yes I will loan it out. You just have to come and pick it up. As well as pulling close to 90 amps at full weld power.

More on the free welder. Tested the TIG function as "scratch" start and that worked well, but we have to turn the gas on and off by hand with the tank valve. After rereading the notes that the past owner made we guessed that he had replaced the bad board. We used the peddle pig tale switch wires to try the board TIG function, and the spark gap system worked, (scared my son as he was sitting right next to it). The spark is a sign the high frequency is working and will jump a gap and start the arc for the TIG to work. We have picked up a 10K Potentiometer(same that is in the factory peddle) with on/off switch. Wired this to the TIG peddle pig tale. We worked the "POT/SWITCH" by hand and the machine will TIG as it should. I thank Terry again for the welder.

Some times you just go to stand up and say, "WTF".

That is a good looking mount.

I guess it is on my end, no worries, still a sweet knife.

For some reason all I see is a sound play back.

Good looking knife, sounds good.

WELL YEA!!!

Be sure to get some pics for us.

Item location: днепропетровск, default, Ukraine

No help here.

Target you can make your self. https://www.youtube.com/watch?v=jvhI5EZPKDA

Imports are out there, and 922 compliance would be needed. as posted before. https://www.thefirearmblog.com/blog/2010/05/21/european-ar-15-rifles/

Thanks for sharing.

Thanks

You can use a GOOD file to break the hard surface before you drill.

When the POS that slapped you comes around the corner, knee cap him!

Paper maps are Ok to know how to read, I taught my son how to read paper maps, getting them folded up correct is a another thread.

Yes, to a point, might run a few more rounds (100) or so. Do you know what brand ammo failed? Was the fails in just one magazine, how many magazines do you have?

Lead free primers have a "shelf life" from what I understand. There was a vendor on this site that posted about the "shelf life". How long will the primer last is unknown, please keep us in the loop.